Table of Contents
Advertisement
12
Ioline FlexJet E Quick Start Guide
i
Note
The cross-member is reversible
and can be attached from either
side.
Caution
Do not hold the printer
head by the bottom edge
of the end plates when
attaching it to the stand. Fingers
and hands might get pinched
between the end plates and stand
legs. Hold the bottom of the end
covers when handling the printer.
Step 3: Attach the Cross-member
1.
Examine the diagrams showing proper placement of the cross-
member in the figure below before proceeding with assembly.
2.
Align the correct holes in the right leg with the threaded holes
in the cross-member.
3.
Insert two 1-inch socket head screws into the threaded holes.
Leave them loose.
4.
Repeat this procedure for the left leg. Make sure that the support
blocks on both leg point the same direction.
5.
Place the stand assembly upright.
6.
Tighten all four cross-member screws.
1-in Screw (4)
Cross-member
Proper placement of the cross-member on FlexJet E model.
1-in screw—at actual size.
Right Leg
Plastic
Support
Block
Advertisement
Table of Contents
