Table of Contents
Advertisement
Step 3 : Feeding Paper
The figure below shows the proper paper paths. The left side of
the diagram shows the paper path for a 1H FlexJet E. The right side
shows the proper path for a FlexJet E with 2 or more heads and a
high speed printing kit.
1.
If the pinchwheels are lowered, raise them by pushing the
pinchwheel lever away from the machine.
2.
Pull a long leader of paper off of the paper roll and insert it
through the stand, behind the printer head, over the platen,
and between the platen and pinchwheels.
3.
Temporarily lock the paper in place by pulling the pinchwheel
lever toward the machine to lower the pinchwheels.
Front
Dancer Bar
Take-up
Shaft
Feed Roll
Proper Paper Path
1H FlexJet E
Proper Paper Path
2H+ FlexJet E
Hint
An alternate take-up method that
will ease removal of markers is
to slide a cardboard tube over
the take-up shaft then tape paper
to the tube. The cardboard tube
will rotate slowly at first and may
not raise the front dancer bar
but will still roll up completed
markers. Simply slide the tube off
the take up shaft when plotting is
complete.
i
Note
Ensure that the paper is properly
positioned for its width. See Step
1 under Paper Loading earlier in
this chapter.
25
Advertisement
Table of Contents
