Table of Contents
Advertisement
16
Ioline FlexJet E Quick Start Guide
Step 5: Level the Stand
1.
Use the wrench to loosen the
leg leveling feet, turning them counter-clockwise. Place a level
across the top of the right stand leg. (See Figure)
2.
Turn the
/
-in nut on each leveling foot counterclockwise to
1
2
lower the foot or clockwise to raise the foot until the leg is level.
Repeat this procedure for the left leg.
After legs are level,
check stand level at
Cross-member
Stand Leveling
Foot
Placement of the level on the stand.
3.
Place a level on the cross-member. Repeat the adjustment
procedure as above except adjust both front and rear levelers
on each leg the same amount so that the legs stay level but the
cross-member moves. Adjust the threaded feet until the stand
is level on the cross-member.
4.
Check the level of the legs again and make small adjustments
as necessary until the stand is level in both directions.
5.
Tighten all of the
/
-in lock nuts on the levelers by turning
9
16
them clockwise.
/
-in lock nut on both of the right
9
16
Check Stand Level
on legs first
Advertisement
Table of Contents
