Section 10-Storage; In-Water Storage Preparation; Lifting The Boat - Formula Cruiser Owner's Manual

Storage/winterization requires special preparation
to prevent damage to the boat, propulsion units,
generator and other equipment. Perform all annual
maintenance at this time.
Without proper preparation, storage for long
periods of time may cause internal parts of the
engine and drive units to rust due to a lack of
lubrication. Water inside the bilge or cooling
system may also freeze and cause damage to
components if the boat is stored in below freezing
temperatures. Damage to the boat due to
improper storage will not be covered by the
warranty. The following procedures should help
prevent damage to your boat.
IN-WATER STORAGE
PREPARATION
While the boat is still in the water, fill the fuel tanks
and add the proper amount of fuel stabilizer and
conditioner. Follow the instructions on the label.
Operate the engines and generator for at least 15
minutes to be sure the treated fuel has reached
them.
NOTICE
Follow the engines and generator's
recommendation for treating the
equipment with a rust preventative fogging
oil. Fogging oil should be used if the boat
is to be stored in a high moisture
(humidity) environment, in extreme
temperatures or stored outdoors.
FORMULA
Section 10
Storage

LIFTING THE BOAT

To prevent structural damage to your Formula
boat, the proper procedure must be used when
lifting your boat. The recommended method of
removing the boat from the water is to use lifting
slings. Slings must be the flat, wide belting-type.
Do not use cable-type slings. The spreader bars
used with the slings must be long enough to avoid
pressure to the gunwales.
1. Spreader Bar
CRUISER/SUPERSPORT
FOR095
Lifting with Slings
Figure 10-1
1
10-1