Table of Contents
Advertisement
Party Mode Shortcut:
To route a single input program to all outputs, also known as party
mode, use the select key followed by the desired input:
Select, # Sends input # to all outputs
Last Command Feedback
The normal display shown on the front panel display can be
changed to the command feedback screen. This screen will display
the last received command, and is very helpful during control
system programming and debugging.
To access this screen, use the < (left arrow) or > (right arrow)
buttons either on the front panel or the IR remote until the Last
Command screen is displayed.
Setup Menu
The user setup menu is only accessible with an IR remote, not from
the front panel. The same settings can also be controlled from the
serial ports. Refer to the Serial Protocols document for more
information on the commands.
To start the setup menu, press Setup on the remote control.
Use the < (left arrow) and > (right arrow) buttons to navigate
through the different options.
Use the Select button to change any of the optional settings.
The menus are as follows:
9
Juneau Matrix Switch User's Guide (DOC42-00026-A_NeoPro-Juneau.doc)
Advertisement
Table of Contents
