In the normal powered on mode, the Fallbrook and Gillespie will
display the last command received. This is helpful for
troubleshooting your control sequences. If the last command
attempted was not received properly or was not formatted
correctly, it will not appear on the display.
You can also use the left/ right arrow keys and the select button to
access the setup menu. The setup options will be discussed in the
next section. Generally when you are presented with a choice on
the display, pressing select will toggle through the choices.
Changes in the matrix switch performance or features take place
right away, so changes do not need to be saved manually.
Controlling from an IR remote control
Controlling the matrix switch using IR follows the basic sequence
of:
#, Out, # # – Standard sequence for switching. Note that the
output number is always two digits, so output 1 is represented by
"01"
Party Mode Shortcut:
To route a single input program to all outputs, also known as party
mode, use the select key followed by the desired input:
Select, # Sends input # to all outputs
Last Command Feedback
The normal display shown on the front panel display can be
changed to the command feedback screen. This screen will display
the last received command, and is very helpful during control
system programming and debugging.
10
Delano Matrix Switch User's Guide (DOC42-00022-A_NeoPro-Delano.doc)