Table of Contents
Advertisement
Operation
Overview
The Juneau is designed to be controlled form a third party control
system, either via RS232 or IR. The buttons on the front panel
allow the control of power and status feedback, however matrix
control must be performed from external sources.
Using the front panel
The Juneau matrix switch front panel uses NeoTouch™
technology. This is different from many other front panels you
have seen with 'membrane' or 'dome' type buttons. The
NeoTouch™ panel senses a human finger touching the acrylic
panel without any moving parts. You need not press hard to
activate a button--a light tap will do.
Powering the Juneau switch on and off is accomplished by
pressing the power button once.
Two button presses are required to shut down the matrix.
In the normal powered on mode, the Juneau will display the last
command received. This is helpful for troubleshooting control
sequences. If the last command attempted was not received
properly or was not formatted correctly, it will not appear on the
display.
You can also use the left/ right arrow keys and the select button to
access the setup menu. The setup options will be discussed in the
next section. Generally when you are presented with a choice on
the display, pressing select will toggle through the choices.
Changes in the matrix switch performance or features take place
right away, so changes do not need to be saved manually.
7
Juneau Matrix Switch User's Guide (DOC42-00026-A_NeoPro-Juneau.doc)
Advertisement
Table of Contents
