Table of Contents
Advertisement
Last Command Feedback
The normal display shown on the front panel display can be
changed to the command feedback screen. This screen will display
the last received command, and is very helpful during control
system programming and debugging.
To access this screen, use the the < (left arrow) or > (right arrow)
buttons either on the front panel or the IR remote until the Last
Command screen is displayed.
You may leave the display set to the Last Command screen to
assist you in programming. This will display the last command
received from IR, RS232 or USB interfaces
Setup Menu
The user setup menu is only accessible with an IR remote, not
from the front panel. The same settings can also be controlled from
the serial ports. Refer to the Serial Protocols document for more
information on the commands.
To start the setup menu, press "Setup" on the remote control.
Use the < (left arrow) and > (right arrow) buttons to navigate
through the different options.
Use the "Select" button to change any of the optional settings.
The menus are as follows:
Setup:Panel LEDs
This option will turn off all the front panel LED lights. The
matrix's behavior is otherwise unchanged. The default in ON
10
Imperial Matrix Switch User's Guide (DOC42-00010-A_NeoPro-Imperial.doc)
Advertisement
Table of Contents
