NeoPro JUNEAU Integrator Manual page 10

Setup: Panel LEDs
This option will turn off all the front panel LED lights. The
matrix's behavior is otherwise unchanged. The default in ON
Setup: Disp Lamp
This option will set the display brightness to one of four levels.
The default is 100%
Setup: AC Pwr
This option control what the matrix will do when AC power is first
applied, or after a power outage. Selecting "ON" (default) will
force the unit to turn on, and the previous switch state will be
restored. Selecting "Stby" will cause the unit to enter standby
mode.
Setup: Touchpanel
This option will enable or disable the front panel buttons. The
default in ON, which means enabled.
Setup: TouchSense
Setup: TouchDelay
These two options work together to control the front panel touch
button performance. The TouchSense setting controls the overall
sensitivity, while the TouchDelay setting controls the detection
delay, similar to a 'debounce' function.
If the buttons are falsely triggered by outside interference, setting
the TouchSense to "LOW" and the TouchDelay to "HIGH" will
likely remedy the situation.
If the buttons are difficult to press with smaller fingers, setting the
TouchSense to "HIGH" will improve the sensitivity. Setting the
TouchDelay to "LOW" will not change the sensitivity, but will
make the button response faster.
10
Juneau Matrix Switch User's Guide (DOC42-00026-A_NeoPro-Juneau.doc)