Controlling From An Ir Remote Control - NeoPro JUNEAU Integrator Manual

Controlling from an IR remote control

IR Control follows the basic sequence of:
#, Out, # # The Juneau has been optimized for a short
command sequence using only 4 IR codes. The first button selects
the input number. The NeoPro remote (Fig. 1, below) uses the
bottom row of buttons for selecting inputs 10-12.
Output selection is a sequence of 2 numeric buttons, i.e.. "0 6"
selects output 6.
Figure 1 - IR Remote numeric button locations
8
Juneau Matrix Switch User's Guide (DOC42-00026-A_NeoPro-Juneau.doc)