Introduction Congratulations on your selection of the Delano HD Video Cat5 matrix switch. Features: • 8 inputs of component video (YpbPr) • 16 outputs of component video • High bandwidth video section (140 MHz) for 480i up to 1080p. • Full non blocking matrix – any input to any output •...
It is OK to place other equipment directly on top of or below the Delano. The Delano is equipped with padded feet so it may be stacked on top of other equipment without causing damage. In either case, to avoid scratches, never slide equipment on top of one another.
Outputs An output zone is made up of one Cat5 cable from the Delano. The Hornet also has audio capabilities when used with the Concord matrix switch, however with the Delano these features are not utilized.
Below is the color codes for 568-B. Although in some case of Ethernet where polarity of the pairs can be swapped, with the Delano system each pair must be in the correct order and polarity. A good practice is to use a cable tester on each cable after termination to verify pin order before using the cable.
For the command protocols, please refer to the manual entitled “Integrator’s Guide to Serial Protocols”. If you plan to use the USB communication feature of the Delano, connect the USB cable to the PC’s USB port (flat end), and the other end (square end) to the Delano matrix switch.
Operation Overview The Delano is designed to be controlled form a third party control system, either via RS232 or IR. The buttons on the front panel allow the control of power and status feedback, however matrix control must be performed from external sources.
The normal display shown on the front panel display can be changed to the command feedback screen. This screen will display the last received command, and is very helpful during control system programming and debugging. Delano Matrix Switch User’s Guide (DOC42-00022-A_NeoPro-Delano.doc)
This option will turn off all the front panel LED lights. The matrix’s behavior is otherwise unchanged. The default in ON. Setup:Disp Lamp This option will set the display brightness to one of four levels. The default is 100%. Delano Matrix Switch User’s Guide (DOC42-00022-A_NeoPro-Delano.doc)
Any of the above selections will be applied instantly. There is no need to save the changes. At any time the user may press exit to return to the home screen, or wait 10 seconds and the home screen will return on it’s own. Delano Matrix Switch User’s Guide (DOC42-00022-A_NeoPro-Delano.doc)
Spray any liquids onto a cotton towel first (never use paper towels as they are abrasive), then wipe the front of the Delano with the moist towel. Should the Delano matrix switch fail to operate as expected, please contact NeoPro for service advice.
2 years. This warranty applies to the original end-user purchaser and installation service provider. NeoPro will, solely at its option, repair or replace this product with a functionally equivalent new or factory-reconditioned product during the warranty period. The consumer should contact the installation service provider that resold the product who will in turn deliver the product to NeoPro.