Wireless Detectors For Walk-Test - Pima hunter-pro User Manual

HUNTER-PRO Intruder Alarm System - User Manual
facsimiles, etc.) are not active. If the fault persists, call the installer.
Tamper switch 1 is open. Call the installer.
Tamper 1
Tamper switch 2 is open. Call the installer.
Tamper 2
Appears before the back-up battery is completely discharged, usually after a
Low pwr
prolonged power failure. Follow instruction for low battery failure.
Parameter programming fault. Call the installer.
EEPROM
One of the protected zones is faulty. Call the installer.
Zone Trb.
Software failure. Call the installer.
ROM
System failure. Call the installer.
RAM
Failure to communicate with Monitoring Station. Call the installer.
Commun.
Detector power supply. Call the installer.
Det. Vltg
No communication between the keypad and the HUNTER-PRO motherboard.
Keypad not
Call the installer.
connected
Other display Programming is done from another keypad or system is controlled via
use telephone.

4.2 Wireless Detectors for Walk-Test

"Walk Test" tests the strength of the radio transmission from the detector to the
HUNTER-PRO only. During the Walk Test, the display will show the letter
The Walk Test is valid for only 10 minutes from the time you start it. After 10 minutes
you have to restart the Walk Test from the beginning.
END
Press any time to end the Walk Test procedure.
While performing the Walk Test, the name of the zone with its associated reception
quality (Radio Strength Signal Indicator) will be displayed in readings from 1 to 10
where 10 represents the best reception quality.
31
W
.