Chapter 4 Troubleshooting; Troubleshooting - Pima hunter-pro User Manual

30
The HUNTER-PRO regularly checks itself and the devices that are connected to it. The
red failure indication lamp will blink if the HUNTER-PRO detects any failure, and in some
cases a failure will be reported to the monitoring station and/or private telephone number
(according to installation programming.) A description of the failure will be displayed in
the keypad and the failure event will be saved in the system memory with date and time.

4.1 Troubleshooting

NOTE:
If more then one failure is detected, the display will scroll the failure list one after
the other. If more than one keypad is connected to the HUNTER-PRO, and you
are programming the system from one keypad, then the display on all other
keypad will display:
displayed whenever the installer uses a modem in order to program the HUNTER-
PRO, or when someone is in control of the HUNTER-PRO via telephone.
The following table describes the possible Alarm System Faults:
Displayed
Fault
Battery
Wireless
Receiver
AC voltage
Clock
Displayed
Fault
Phone
Other display is used
What can I do?
Wait approximately 24 hours for the indication to disappear. If the fault
indication persists longer then one day, the back-up battery should be replaced.
A wireless receiver failure can be the cause of communication
failure between the detector and receiver.
Usually appears during a power failure. If other electrical appliances in the
house are operating, check the switch or fuse to which the alarm system is
connected. If the cause of the fault is unclear, call the installer.
Appears following a prolonged power failure during which the backup battery
was completely discharged. Set time and date (see section 3.8.4)
What can I do?
Perform "system self-test" (see section 3.6). Verify during the test that other
instruments connected to the Alarm System's telephone line (i.e., telephone sets,
Anti-Vandal Keypad Model
Chapter 4
Troubleshootin
This will also be