Arris DCX3600-M User Manual page 4

Safety and Regulatory
Install the terminal so that there is a minimum of two inches of space between surrounding surfaces and the top, left,
•
and right sides of the terminal to ensure proper ventilation.
Install the terminal away from heat sources such as radiators, heat registers and stoves. Installation of the terminal
•
near consumer electronics devices, such as stereo receiver/amplifiers and televisions, is permitted as long as the air
surrounding the terminal does not exceed 40 ºC (104 ºF).
• Place the terminal on a flat surface not prone to vibration or impact.
Do not place the terminal on top of another electronic device.
•
Do not install the terminal in an area where condensation occurs.
•
To prevent the temporary loss of guide data and cause a temporarily non-responding terminal, do not plug the AC
•
power cord into a switched power outlet.
ADDITIONAL SAFETY CONSIDERATIONS FOR DVR MODELS
• To avoid shock and vibration damage to the internal hard drive, do not move the terminal while it is plugged in.
To allow the hard drive to spin down and park its heads, wait at least 10 seconds after disconnecting power before
•
moving the terminal.
Install the terminal so that there is a minimum of 3 inches of space between surrounding surfaces and the back of
•
the terminal to ensure proper ventilation.
FCC COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and set-top.
•
• Connect the equipment into an outlet on a circuit different from that to which the set-top is connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by ARRIS for compliance could void the user' s authority to operate the
equipment.
FCC DECLARATION OF CONFORMITY
ARRIS Enterprises, Inc., 101 Tournament Drive, Horsham, PA 19044, 1-215-323-1000, declares that this Class B digital device
complies with 47 CFR Parts 2 and 15 of the FCC rules.
INDUSTRY CANADA (IC)
This Class B digital device complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Set-Top Entertainment Hub DCX3600-M • User Guide
365-095-25659 x.1
ii