Output Channel - Filters - QSC TouchMix-8 User Manual

Output Channel – Filters
Available on the Main L/R and Aux 1 – 6 (TouchMix-16,) and 1 – 4 (TouchMix-8) outputs. These narrow, cut-only, filters are useful for dealing
with feedback.
Home Select the
Aux Bank
Aux Outputs
— Figure 35
Refer to
1. Filters Tab – Selects the Filters screen
2. Filter In Buttons – Engages a single Filter.
3. Lo Cut – Attenuates, or "cuts" frequencies below this frequency setting. Range is 20 Hz
to 2 kHz. The slope of this filter is 18 dB/octave.
4. Nraph – Graphic representation of engaged filters.
• Vertical scale = dB
• Horizontal scale = frequency
5. Hi Cut – Attenuates, or "cuts" frequencies above this frequency setting. Range is 200 Hz
to 20 kHz. The slope of this filter is 18 dB/octave.
6. Freq Knob – Sets the center frequency of a filter.
7. Cut Knob – Sets amount of Cut (or attenuation) for a notch filter.
NOTE!: Aux Outputs 7/8 & 9/10 have only low- and high-cut filters.
(TouchMix-16, only)
8. Filters In Button – Enables / disables individual filter engagement.
9. Reset Button – Sets all the Filter controls to their factory default position.
TD-000472-00-B
Touch a
Select Button
Filters Tab
Aux 1 or Main
41
Select
Filter
1
2
3
4
5
2
6
7
8 9
— Figure 35 —