Using The Input Channel Fx Tab - QSC TouchMix-8 User Manual

Using the Input Channel FX Tab

You can also operate your effects from the input channel area of your mixer.
To Run Effects from the Input Channel:
Welcome to the channel FX screen. From here you can...
Select a Different Processor:
1
2
3
Select a Preset: 4
Send to the Effect:
-40 -20 -10
Adjust Global FX Parameters (Advanced Mode Only):
These controls are called "global" because all channels using this FX mix are affected by these controls. The Sends fader, however is adjusted for each
individual channel.
Using Pitch Correct:
Enable
There is one Pitch-Correct processor available on the mixer. Touch the Enable button to assign it to the currently selected channel.
◦ Use the Blend control to vary the mix between corrected (wet) and uncorrected (dry) signal. 100% wet is used to correct pitch. A blend
between wet and dry is used to provide a doubling effect.
◦ Use the Key control to select a musical key. This helps Pitch Correct be more accurate in determining what the intended note is.
◦ Use the Correct Rate control to adjust how quickly the pitch correction tracks.
TD-000472-00-B
1
2
3
4
Lush Reverb
FX
Presets
See "Select a Preset:" on page
Adjust the fader for each effect you want to use on this channel.
U
-5 5 10
1170
Blend
75%
Dry Wet
In 1
Inputs 1-8
Select an FX Processor:
None Cancel
5. Press Home to come back.
Delay Feedback
31.0
mSec %
Key Correct-Rate
5.0
C  /D 
(Slow-Fast)
6
FX