Lexus IS250 U Owner's Manual page 480

480
8-2. Steps to take in an emergency
Warning message
(U.S.A. only)
(If equipped)
(If equipped)
(Flashes)
(If equipped)
(If equipped)
*
: Refer to the separate "Scheduled Maintenance" or "Owner' s Manual Supplement"
for the maintenance interval applicable to your vehicle.
IS350/250_U (OM53C50U)
Details/Actions
Indicates that all maintenance is required to correspond
to the driven distance on the maintenance schedule
Comes on approximately 5000 miles (8000 km) after
the maintenance data has been reset.
(The indicator will not work properly unless the mainte-
nance data has been reset.)
 Perform the necessary maintenance. Please reset
the maintenance data after the maintenance is per-
formed (P. 403)
Indicates that the Automatic High Beam switch is
pressed while the headlights are in low beam.
 Turn the high beam on and press the Automatic
High Beam switch again.
Indicates that, since the VSC (Vehicle Stability Control)
system was turned off, the pre-collision brake system
operation is stopped
 Turn the VSC on. (P. 242)
Indicates that the PCS (Pre-Collision System) is not cur-
rently functional because the grille cover or the sensor is
dirty
 Check the grille cover and the sensor and clean
them if they are dirty.
Indicates that operation of large electricity consuming
systems such as the air conditioning system are sus-
pended
 Stop using unnecessary electric components to
reduce electricity consumption. Wait a while until
the electric power supply is restored.
Indicates that the LDA (Lane Departure Alert) system
cannot be used because the vehicle speed is lower than
approximately 32 mph (50 km/h)
 Drive the vehicle at 32 mph (50 km/h) or higher.
*
.