Table of Contents
Advertisement
Important!
The first time you use the washing machine,
when you switch it on, it may display a blinking zero.
This is due to the fact that the washing machine has
performed a washing cycle during the manufacturer's
inspection tests, and this cycle has not been erased
after its completion.
• Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the START/PAUSE button,
the countdown begins, and the delay time value
decreases by one unit every hour till the first 2
hours, and then it decreases by one unit every 30
minutes.
You can delay the start of every programme
selecting the DELAY START button. The delay time
is indicated first by 30-60-90 minutes, and then by
hours up to 23 hours.
• An incorrect option selection has been made:
this is indicated by the message Err when a
function incompatible with the current programme
is selected.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 22).
9 START/PAUSE button
This button has two functions:
• Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
If you have selected a delay time by means of the
relevant button, the countdown will begin and will
be shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
10 SKIP RESET button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the washing machine on, the blinking zero will
reappear.
You can also press the SKIP RESET button to
exclude one or several phases of the programme
which is running, as indicated below.
- set the washing machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the SKIP RESET button once or several
times, until the required phase(s) is(are) cancelled
10
Advertisement
Table of Contents
