Direct Call Status Indicator
Note:
To initiate Direct Call, press the Top Button followed by the PTT button to talk directly and privately to the
pre-set user.
Direct Call Status
Direct Call initiated (using Top
Button press) – Initiator party
Private conversation initiated
(using the PTT button) – Initiator
Private Call notification – Receiver
Private conversation in progress –
Both parties
End of private conversation – Both
Notes:
Direct Call times out after 10 seconds of inactivity (no transmissions detected). Voice prompt "Private
Over" will be heard by both users involved in the private call.
Top Button must be pre-programmed to Direct Call Feature. For Direct Call feature to be enabled in the
radio Advanced Configuration, a radio ID must have been uploaded into the radio via CPS. Radio will
play voice prompt of Direct Call Name. If no name is programmed, radio announces radio private ID
number. Refer to "Customer Programming Software (CPS)" on page 83 for more information.
(*) According to the private user name that has been set up via CPS.
60
English
Table 2: Direct Call Status Indicator
Top Button LED Indicator
party
party
parties
Blink Orange
Solid Orange
Solid Orange
Solid Orange
Off
Voice Prompt or Tone
"<Name of Direct Call user>"(*)
Private TPT
"Private"
Private TPT
"Private Over"