Turning Radio On/Off; Adjusting Volume - Motorola DLR1020 User Manual

TURNING RADIO ON/OFF

To turn ON the radio, press and hold the Power
button until the radio plays the power up tone
and the standby light begins to blink.
Note: By default, when radio is turned ON, it
announces the current channel name and
battery status.
To turn the radio OFF, press and hold the
Power button (~3 seconds) until the radio Tx/
Rx Indicator LED turns OFF and power down
tone is heard.

ADJUSTING VOLUME

Press the (+) button to increase the volume, or
the (-) button to decrease the volume.
To mute, press and hold the (-) button (~2
seconds) until you hear the voice
announcement "Mute".
Note: Radio mute means setting the volume to the
lowest level. (This is to prevent the user
from forgetting to unmute the radio.)
To maximize volume, press and hold the (+)
button (~2 seconds). The volume will fast scroll
26
English
up to maximum volume. You will hear the
volume beeps increment as the volume
increases.
Notes: Do not hold the radio too close to the ear
when the volume is high or when adjusting
the volume.
There are 16 increments of volume.
As the (+) / (-) buttons are pressed, you will
hear a beep at the current volume level. If
device is receiving during volume
interaction, received audio will be heard at
the new volume instead of beeps.
When using radio with earpiece, make sure to
adjust the radio volume to the lowest volume
before putting on the earpiece. Refer to
"Acoustic Safety" on page 3. Use only Motorola
approved accessories. Refer to "Audio
Accessories" on page 113 for more information.