Cloning Radio Using The Radio To Radio (R2R) Cloning Cable (Optional Accessory); Operating Instructions - Motorola DLR1020 User Manual

4. After cloning is completed, the Source radio will
announce either "pass" (cloning is successful)
or "fail" (cloning has failed).
5. Once you have completed the cloning process,
turn the radios OFF and ON or, long press the
PTT button to exit the 'cloning' mode.
When ordering the MUC, refer to P/N#
PMLN7136_.
Notes:
• If cloning fails, refer to "What To Do If Cloning
Fails" on page 99.
• Paired Target radios and Source radios must be
of the same band type in order for the cloning to
run successfully.
• MUC pockets numbers should be read from left to
right with the Motorola logo facing front.
98
English
Cloning Radio using the Radio to Radio
(R2R) Cloning Cable (Optional Accessory)
Note:

Operating Instructions

1. Before starting the cloning process, make sure
you have:
• A Cloning Cable (P/N# HKKN4028_)
• A fully charged battery in each of the radios.
• Two Single-Unit Chargers (SUC) for cloning
DLR Series radios.
• Turn OFF the radios and,
2. Unplug any cables (power supply or USB
Uses Cloning Cable
P/N# HKKN4028_