Wireless Profile Id Number Cloning - Motorola DLR1020 User Manual

4. Ensure that there is no debris in the charging
tray or on the radio contacts.
5. Ensure that the Target radio is turned ON.
6. Ensure that the Source radio is in cloning mode.
7. Ensure that the two radios are both from the
same type (i.e.:DLR series), same region and
have the same transmission power.
Note: This cloning cable is designed to operate
only with compatible Motorola SUC
PMLN7140_.
When ordering Cloning Cable Kit, please refer
to P/N# HKKN4028_. For more information
about the accessories, refer to "Accessories"
on page 113.
100
English

Wireless PROFILE ID Number Cloning

The PROFILE ID Number Wireless Cloning
feature is useful when you want to clone the
PROFILE ID Number for all the radios in your
fleet but you do not want to clone particular
radio settings that may be unique for each
radio (like top button configuration, Microphone
Gain, Radio Name etc) across. Wireless
PROFILE ID helps to preserve each user radio
set up but still make sure all radios are under
the same PROFILE ID Number. It is also useful
if you do not have a programming Cable,
Cloning Cable or PC easily available.
To wirelessly clone the PROFILE ID Number:
1. Power the Source radio following the sequence
below:
• Press the PTT button and the (-) button
simultaneously while turning the radio
ON.
• Wait for 3 seconds before releasing the
buttons until the audible tone and voice
announcement "Clone Mode Serial" are
heard.