Cloning The Wireless Profile Id Number - Motorola DTR600 User Manual

Cloning the Wireless PROFILE ID
Number
The PROFILE ID Number Wireless Cloning feature is
useful when you want to clone the PROFILE ID Number for
all the radios in your fleet but you do not want to clone
particular radio settings that may be unique for each radio
(like top button configuration, Microphone Gain, Radio
Name etc) across. Wireless PROFILE ID helps to preserve
each user radio setup but still ensure that all radios are
under the same PROFILE ID Number. It is also useful if
you do not have a programming Cable, Cloning Cable or
PC easily available
1 Power the Source radio by performing the following
actions:
a Press the PTT button and the (-) button
simultaneously while turning the radio on.
b Wait three seconds before releasing the buttons
until the audible tone and voice announcement
"Clone Mode Serial" are heard.
c Press and release the (-) button.
The Source Radio announces "Wireless".
2 Power on Target radio by performing the following
actions:
a Press the PTT button and the (-) button
simultaneously while turning the radio on.
b Wait three seconds before releasing the buttons
until the audible tone and voice announcement
"Clone Mode Serial" are heard.
NOTICE:
Avoid putting powered on radios (more than
seven radios) in a container, other than the
Multi-Unit Charger, bunched together,
touching each other.
3 To start the wireless PROFILE ID Number cloning on
the Source radio, press and release the (+) button .
• The radio generates an audible tone.
• After cloning is completed, the Source radio will
announce either "pass" (cloning is successful) or
"fail" (cloning has failed).
• On the Target radio, the radio receives the
PROFILE ID Number information. The Target
radio will announce either "pass" (cloning is
successful) or "fail" (cloning has failed).
English
55