Ordering Parts - Icom IC-PW1 Service Manual Addendum

INTRODUCTION
This service manual describes the latest service information
for the IC-PW1 HF/50 MHz ALL BAND LINEAR AMPLIFIER
and the PX-1981 POWER SUPPLY UNIT at the time of
publication.
MODEL VERSION
U.S.A.
IC-PW1 Europe
Europe-1
To upgrade quality, all electrical or mechanical parts and inter-
nal circuits are subject to change without notice or obligation.

ORDERING PARTS

Be sure to include the following four points when ordering
replacement parts:
1. 10-digit order numbers
2. Component part number and name
3. Equipment model name and unit name
4. Quantity required
<SAMPLE ORDER>
1140003830 S.IC TC4W66F
8810003160 SET Screw 3 × 6 ZK
Addresses are provided on the inside back cover for your
convenience.
SYMBOL
USA
EUR
EUR-1
IC-PW1 MAIN UNIT 1 piece
IC-PW1 CHASSIS 6 pieces
DANGER
THE IC-PW1
include an AC power supply. Therefore,
NEVER
touch the PX-1981 unit while the linear amplifier
is connected to an AC outlet, otherwise an electric shock
may be received. An insulated tool must be used at all
times.
ONLY
Use the specified AC voltage labelled on the AC
power socket of the IC-PW1. Other voltages could cause a
fire hazard.
THE IC-PW1
IC accepts 13.8 V DC ONLY. NEVER con-
nect to an AC outlet. Such a connection could cause a fire
hazard and/or electiric shock.
DO NOT
expose the linear amplifier to rain, snow or any
liquids.
NEVER
carry the linear amplifier by yourself. At least
two persons must carry the linear amplifier since it weights
approx. 25 kg (55.12 lb).
REPAIR NOTES
1. Make sure a problem is internal before disassembling
the linear amplifier, power supply or remote controller.
2. DO NOT open the linear amplifier, power supply or
remote controller until the power supply is disconnected
from its power source.
3. DO NOT force any of the variable components. Turn
them slowly and smoothly.
4. DO NOT short any circuits or electronic parts.
insulated tuning tool MUST be used for all adjustments.
5. DO NOT keep power ON for a long time when the linear
amplifier is defective.
6. READ the instructions of test equipment thoroughly
before connecting equipment to the linear amplifier.
An