Motorola AP-8132 Installation Manual page 16

16
6. Use a drill to make a hole in the tile the approximate size of the Access Point LED light pipe.
CAUTION
7. Remove the light pipe's two rubber stoppers (from the Access Point) before installing the light pipe.
8. Connect the light pipe to the bottom of the Access Point. The dual channel light pipe is mated to the
Access Point by firmly pressing the light pipe into the two round openings that contained the two rubber
plugs removed in the previous step.
9. Fit the light pipe into hole in the tile from its unfinished side.
10. Slide the badge onto the light pipe from the finished side of the ceiling tile.
11. Attach the antennas to their correct connectors. For more information on supported AP-8132 antennas,
see AP-8132 Antenna Options on page 18
NOTE
12. Align the ceiling tile into its former ceiling space.
Motorola recommends care be taken not to damage the finished
surface of the ceiling tile when creating the light pipe hole and
installing the light pipe.
Motorola recommends attaching safety wire to the Access Point safety
wire tie point or security cable (if used) to the Access Point's lock port.
.
AP-8132 Access Point