Panasonic KX-NT700 Operating Instructions Manual page 32

Making and Answering Calls
•
If a pause is required when making a call on the
TEL line, press [REDIAL/PAUSE] between
digits as necessary.
3.
Press [ ] or .
4.
To end the call, press [
Redialing
The last 10 calls made are stored in the redial list, in
order of newest to oldest call.
1.
Press [REDIAL/PAUSE].
•
The last call made is displayed.
2.
Press [ ] or [ ] repeatedly to scroll through the
list.
•
To erase the displayed item, press
•
To exit the redial list, press [MENU].
3.
When the desired entry is displayed, press [
.
Note
•
The line that was used to make each call in the
redial list ("IP" or "TEL") is shown in the
lower-right corner of the display. This line will be
used when the call is redialed.
Example:
•
If the "Line Selection" setting is not set to
"IP + TEL" (see page 30), TEL line calls
cannot be redialed.
•
If the dialed number contains too many digits
(more than 32 digits for IP calls with IP-PBX
connection, more than 128 digits for TEL calls),
it cannot be redialed correctly.
Entering Dialing Pauses
A pause is sometimes required when making calls on
the TEL line using a PBX or a long distance service. For
example, if you must dial "9" before dialing an outside
phone number, you probably wait (pause) after dialing
"9" until you hear a dial tone.
By pressing the [REDIAL/PAUSE] button when dialing,
the unit will store the dialing pause along with the phone
number in the redial list. If you make a call from the
redial list later, the unit will dial the number wait for the
pre-programmed number of seconds (default: 3 s; see
page 51) for each dialing pause you entered.
32 Operating Instructions
].
.
ERASE
] or
The TEL line will
be used when
you redial this
number.
Example:
1.
Press [9] (to access an outside line of a PBX).
2.
Press [REDIAL/PAUSE].
•
Press [REDIAL/PAUSE] repeatedly to create
longer pauses. An additional pause is inserted
each time [REDIAL/PAUSE] is pressed.
3.
Dial the phone number.
4.
Press [ ] or .
Making a Call from the Phonebook
See page 37 to add entries to the phonebook.
1.
Press .
2.
Press [ ] or [ ] repeatedly to scroll through the
phonebook entries.
•
Entries are displayed in the following order
when [ ] is pressed.
Symbols®Numbers®Letters
•
Press the dial key corresponding to the desired
character, then press [ ] or [ ] to scroll if
necessary.
•
To exit the phonebook, press [MENU].
3.
When the desired entry is displayed, press [
.
Note
•
The line that was selected when the entry was
stored in the phonebook ("IP" or "TEL") is
shown in the lower-right corner of the display.
This line will be used when the entry is called.
Example:
•
If the "Line Selection" setting is not set to
"IP + TEL" (see page 30), TEL line numbers
cannot be called.
] or
The TEL line will
be used when
you call this
number.
Document Version 2010/02