Making Calls - Panasonic KX-NT700 Operating Instructions Manual

Making Calls

1.
Confirm that the desired line ("IP" or "TEL") is
selected.
•
You can change the selected line by pressing
the center function button ([F2]).
The IP line is selected.
[F2]
•
If you cannot select the desired line, change the
"Line Selection" setting (see page 30).
2.
Press [ ].
3.
For TEL calls: Enter the phone number.
For IP calls with IP-PBX connection: Enter the
phone number.
For IP calls with peer to peer connection: Enter
the IP address, then press [#] or [ENTER].
•
IP addresses can be entered using the keypad.
[0]–[9] are used to enter numbers and [ ] is
used to enter a period. For example, to enter
"192.168.0.1", press [192 168 0 1].
•
To temporarily use tone dialing when the line
mode is set to pulse mode, press [ ].
•
After a call starts, the approximate length of the
call is shown on the display.
4.
To end the call, press [
Note
•
To make a call using the phonebook, see
page 32.
•
To make a call with a Portable Station (PS) or
computer connected to the unit, see page 42
or page 43.
•
During the first 30 seconds of a TEL call, the unit
adjusts itself for optimal sound quality. Speak in
turns with the other party at the beginning of a
conversation. (The time required varies
depending on the condition of the telephone line
and the audio characteristics of the room.)
During this time, sound may cut out or fade in
and out. This is normal.
Document Version 2010/02
The TEL line is
selected.
[F2]
].
•
If the unit is not connected to an IP network,
is not displayed and the IP line cannot
IP
be selected.
•
The call length shown on the display is an
approximation and may differ from the actual
length of the call. Call charges accumulate after
the called party answers.
Adjusting the Speaker Volume
While on a call, press [ ] or [ ] repeatedly to adjust
the speaker volume. There are 8 levels of volume.
Quieter
•
If the other party has difficulty hearing you, press
[ ] to decrease the speaker volume. Your voice
heard by the other party will become louder.
Making a Call After Entering the
Phone Number or IP Address
1.
Confirm that the desired line ("IP" or "TEL") is
selected.
•
You can change the selected line by pressing
the center function button ([F2]).
The IP line is selected.
[F2]
•
If you cannot select the desired line, change the
"Line Selection" setting (see page 30).
2.
For TEL calls: Enter the phone number.
For IP calls with IP-PBX connection: Enter the
phone number.
For IP calls with peer to peer connection: Enter
the IP address.
•
If you make a mistake, press [
the correct phone number or IP address. To
erase all numbers, press and hold [
Making and Answering Calls
Louder
The TEL line is
selected.
[F2]
], then enter
].
Operating Instructions 31