Loose Fuel Filler Cap Message; Emissions Inspection And Maintenance Programs - RAM 2013 Cargo VAN Owner's Manual

Loose Fuel Filler Cap Message

If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
"gASCAP" message will display in the odometer or a
"CHECK GASCAP" message will be displayed in the
Electronic Vehicle Information Center (EVIC). Refer to
"Electronic Vehicle Information Center (EVIC)" in "Un-
derstanding Your Instrument Panel" for further informa-
tion. Tighten the gas cap until a clicking sound is heard.
This is an indication that the gas cap is properly tight-
ened.
Press the odometer reset button to turn the message off.
If the problem persists, the message will appear the next
time the vehicle is started. This might indicate a damaged
cap. If the problem is detected twice in a row, the system
will turn on the MIL. Resolving the problem will turn the
MIL light off.
MAINTAINING YOUR VEHICLE 607
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle's emissions control system.
Failure to pass could prevent vehicle registration.
For states that require an Inspection and Mainte-
nance (I/M), this check verifies the "Malfunction
Indicator Light (MIL)" is functioning and is not
on when the engine is running, and that the OBD II
system is ready for testing.
Normally, the OBD II system will be ready. The OBD II
system may not be ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
7