RAM 2013 Cargo VAN Owner's Manual page 536

534 STARTING AND OPERATING
NOTE: The vehicle may need to be driven for up to 20
minutes above 15 mph (24 km/h) to receive this infor-
mation.
SERVICE TPM SYSTEM Message
The "Tire Pressure Monitoring Telltale Light" will flash
on and off for 75 seconds, and remain on solid when a
system fault is detected. The system fault will also sound
a chime. The EVIC will display a "SERVICE TPM SYS-
TEM" message for a minimum of five seconds. This text
message is then followed by a graphic display, with - - in
place of the pressure value(s) indicating which TPMS
Sensor(s) is not being received.
If the ignition switch is cycled, this sequence will repeat,
providing the system fault still exists. If the system fault
no longer exists, the "Tire Pressure Monitoring Telltale
Light" will no longer flash, the "SERVICE TPM SYSTEM"
message will not be present, and a pressure value will be
displayed instead of dashes. A system fault can occur by
any of the following scenarios:
1. Jamming due to electronic devices or driving next to
facilities emitting the same radio frequencies as the
TPMS sensors.
2. Installing some form of aftermarket window tinting
that affects radio wave signals.
3. Accumulation of excessive snow and/or ice around
the wheels or wheel housings.
4. Using tire chains on the vehicle.
5. Using wheels/tires not equipped with TPMS sensors.
The EVIC will also display a "SERVICE TPM SYSTEM"
message for a minimum of five seconds when a system
fault possibly related to an incorrect sensor location fault
is present. In this case, the "SERVICE TPM SYSTEM"