Reprogramming A Single Homelink® Button; Canadian/Gate Operator Programming - RAM 2013 Cargo VAN Owner's Manual

Reprogramming A Single HomeLink® Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink® button until
the indicator light begins to flash after 20 seconds. Do
not release the button.
3. Without releasing the button proceed with "Program-
ming A Rolling Code" Step 2 and follow all remaining
steps.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 261

Canadian/Gate Operator Programming

For programming transmitters in Canada/United States
that require the transmitter signals to "time-out" after
several seconds of transmission.
Canadian radio frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of trans-
mission – which may not be long enough for HomeLink®
to pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
3