Table of Contents
Advertisement
TECHNICAL SERVICE MANUAL
Phoenix BIOS Error Code Messages
The following are the list of messages that Phoenix BIOS can display. Most of them occur during POST. Some
of them display information about a hardware device, e.g., and the amount of memory installed. Others may
indicate a problem with a device, such as the way it has been configured. The following lists the explanation of
the messages and remedies for reported problems.
NOTE: If your system displays one of the messages marked below with an asterisk (*), write down the
message and contact your dealer. If your system change after you make changes in the Setup menus,
reset the computer, enter Setup and install Setup defaults or correct the error.
Error Codes
0200
0210
0211
0212
0213
0220
*0230
*0231
*0232
0250
0251
*0260
*0270
0271
0280
Failure Fixed Disk
Fixed disk is not working or not configured properly. Check to see if fixed disk is
attached properly. Run Setup. Find out if the fixed-disk type is correctly identified.
Stuck key
Stuck key on keyboard
Keyboard Error
Keyboard is not working
*Keyboard Controller Failed
Keyboard controller failed test. May require replacing keyboard controller.
Keyboard Locked - Unlock Key Switch
Unlock the system to proceed
Monitor type does not match CMOS - Run Setup
Monitor type not correctly identified on Setup
Shadow RAM failed at offset: nnnn
Shadow RAM failed at offset nnnn of in the 64k block at which the error was detected.
System RAM failed at offset: nnnn
System RAM failed at offset nnnn of in the 64k block at which the error was detected.
Extended RAM failed at offset: nnnn
Extended memory not working or not configured properly at offset nnnn.
System battery is dead - Replace and run setup
The CMOs clock battery indicator shows the battery is dead. Replace the battery and
run Setup to reconfigure the system.
System CMOS checksum bd - Default configuration used
System CMOS has been corrupted or modified incorrectly, perhaps by an application
program that changes data stored in CMOS. The BIOS default installed Default Setup
Values. If you do not want these values, enter Setup and enter your own values. If the
error persists, check the system battery or contact your dealer.
System Time Error
The timer test failed. Requires repair of system board
Real Time Clock Error
Real-Time Clock fail BIOS hardware test. May require board repair.
Check date and time settings
BIOS found date or time out of range and reset the Real-Time Clock. May require
setting legal date (1991 - 2099)
Previous Boot Incomplete - Default Configuration used
Previous POST did not complete successfully. POST loads default values and offers to
run Setup. If the failure was caused by incorrect values and they are not corrected, the
next boot will likely fail. On systems with control of wait states, improper Setup settings
can also terminate POST and cause this error on the next boot. Run Setup and verify
that the wait state configuration is correct. This error is cleared the next time the system
is booted.
77
Error Messages
Prestigio Signore 152
Advertisement
Table of Contents
