Table of Contents
Advertisement
Error messages
If you receive an error message, note the message and take the corrective action. The following table lists the error messages
in alphabetical order together with the recommended course of action.
Note: If your system displays one of the messages marked below with an asterisk (*), write down
the message and contact your dealer. If your system fails after you have made the changes in the
Setup menus, reset the computer, enter Setup and load the Setup defaults to correct the error.
Error Messages
Corrective
0200 Failure Fixed Disk
0210 Stuck key
0211 Keyboard error
0212 Keyboard Controller Failed*
0213 Keyboard locked -
Unlock key switch
0220 Monitor type does
not match CMOS - Run SETUP
0230 Shadow Ram Failed
at offset: nnnn*
0231 System RAM Failed
at offset: nnnn*
0232 Extended RAM Failed
at offset: nnnn*
0250 System battery is dead -
Replace and run SETUP
0251 System CMOS checksum bad -
Default configuration used
0260 System timer error*
0270 Real time clock error*
0271 Check date and time settings BIOS found date or time out of range and reset the Real-Time Clock. May require
0280 Previous boot incomplete -
Default configuration used
0281 Memory Size found
by POST differed from CMOS
32
Action
Fixed disk is not working or not configured properly. Check to see if fixed disk is
attached properly. Run Setup. Find out if the fixed-disk type is correctly identified.
Stuck key on keyboard.
Keyboard not working.
Keyboard controller failed test. May require replacing keyboard controller.
Unlock the system to proceed.
Monitor type not correctly identified in Setup
Shadow RAM failed at offset nnnn of the 64k block at which the error was
detected.
System RAM failed at offset nnnn of in the 64k block at which the error was
detected.
Extended memory not working or not configured properly at offset nnnn.
The CMOS clock battery indicator shows the battery is dead. Replace the battery
and run Setup to reconfigure the system.
System CMOS has been corrupted or modified incorrectly, perhaps by an application
program that changes data stored in CMOS. The BIOS installed Default Setup
Values. If you do not want these values, enter Setup and enter your own values. If
the error persists, check the system battery or contact your dealer.
The timer test failed. Requires repair of system board.
Real-Time Clock fails BIOS hardware test. May require board repair.
setting legal date (1991-2099).
Previous POST did not complete successfully. POST loads default values and offers
to run Setup. If the failure was caused by incorrect values and they are not
corrected, the next boot will likely fail. On systems with control of wait states,
improper Setup settings can also terminate POST and cause this error on the next
boot. Run Setup and verify that the wait-state configuration is correct. This error is
cleared the next time the system is booted.
Memory size found by POST differed from CMOS.
PRESTIGIO NOBILE 1560
Advertisement
Table of Contents
