Cr Motor - Epson Stylus C110 Service Manual

EPSON Stylus C110/C120/D120

4.5.11 CR Motor

Part/Unit that should be removed before removing CR Motor
Upper Housing/Lower Housing/Main Board Unit/Left Frame/Panel Unit/Front
Frame/Right Frame
Removal Procedure
1. Turn the Spur Gear 51.5 to release the Carriage Lock, and move the CR Unit to the
center of the printer.
(Refer to 4.5.2 Printhead Step1 (p83))
Be careful not to damage the CR Motor cable when releasing the
C A U T I O N
cable from the hooks of the Main Frame.
2. Release the CR Motor cable from the notches (x3) of the Base Frame and the
hooks (x3) of the Main Frame, and then pull out the cable through the hole of the
Base Frame.
Hook
Notch
Hole
Figure 4-53. Removing CR Motor (1)
DISASSEMBLY/ASSEMBLY
CR Motor Connector Cable
Disassembling Printer Mechanism
After releasing the Timing Belt, temporarily secure the belt to the
C A U T I O N
Cartridge Cover with a tape or the like so as not to allow the grease
to come in contact with the Timing Belt. Contaminating the belt
with grease can result in malfunction of the printer.
3. Loosen the tension of the Timing Belt by pressing the Driven Pulley Holder in the
direction of the arrow as shown in the figure, and release the Timing Belt from the
pinion gear of the CR Motor.
Do not damage the pinion gear of the CR Motor.
C A U T I O N
4. Remove the screws (x2) that secure the CR Motor, and remove it.
Driven Pulley Holder
Timing Belt
Figure 4-54. Removing CR Motor (2)
Revision B
CR Motor Pinion Gear
2 1
C.P. 3x4, F/Zn-3C (4±1kgfcm)
93