Main Frame Assy - Epson Stylus C110 Service Manual

EPSON Stylus C110/C120/D120

4.5.12 Main Frame Assy.

Part/Unit that should be removed before removing Main Frame Assy.
Upper Housing/Lower Housing/Main Board Unit/Left Frame/Panel Unit/Front
Frame/Right Frame/CR Motor/CR Scale/Hopper
Main Frame Assy. consists of the following parts.
C H E C K
P O I N T Main Frame
CR Unit
Printhead
Upper Paper Guide
Removal Procedure
1. Remove the Grounding Spring from the PF Motor.
(Refer to 4.5.10 PF Motor Step2 (p91))
2. Release one end of the Extension Spring from the hook of the Main Frame with a
longnose plier, and then remove the spring together with the Driven Pulley Holder.
Extension Spring
Hook
Figure 4-56. Removing Extension Spring and Driven Pulley Holder
DISASSEMBLY/ASSEMBLY
Driven Pulley Holder
Disassembling Printer Mechanism
3. Move the CR Unit to left side of the printer.
4. Remove the screw (x1) that secures the LD Shaft Holder.
5. Move the LD Shaft Holder in the direction of the arrow while holding down its tab
with a flathead precision screwdriver, and remove the LD Shaft Holder.
Figure 4-57. Removing LD Shaft Holder
6. Remove the Extension Springs 10.99 (x3) from each hook of the Main Frame and
the Upper Paper Guide.
Main Frame
Figure 4-58. Removing Upper Paper Guide (1)
Revision B
LD Shaft Holder
Tab
C.B.P. 3x6, F/Zn-3C (6±1kgfcm)
Extension Spring 10.99
95