Epson Stylus C110 Service Manual page 64

EPSON Stylus C110/C120/D120
Occurrence timing
Detailed phenomenon
CR position
The abnormal noise occurs at the first
power on timing and during each
operation although the printing operation
• Anytime
is performed.
• Anywhere
The Carriage Unit collides to the Upper-
Paper Guide Unit during each operation.
Print Quality State Detailed phenomenon
Ink is scarcely ejected to the Cap from
the Printhead.
• Dot missing and
mixed colors
Ink is ejected to the Cap from the
Printhead, but the printer does not
recover from the error after cleaning or
ink change.
TROUBLESHOOTING
Table 3-13. Check point for the abnormal noise
Defective unit/
part name
1. Check if the grease on the Carriage Path is sufficient.
Carriage Unit
1. Check if the Change Lever moves smoothly.
ASF Unit
Upper Paper Guide 1. Check if the Upper Paper Guide Unit is attached securely.
Unit (check if it interferes with the Carriage Unit)
Table 3-14. Check point for the poor printing quality
Defective unit/
part name
1. Check if there is not any foreign material/damage around
the seal rubber part on the Cap Unit.
Ink System Unit
(Cap Unit)
2. Check if the Compression Spring 1.47 is correctly
mounted on the Cap Unit.
1. Check if it returns to normal by performing CL operation
or replacing the Ink Cartridge.
Printhead
2. Check if the Printhead is not damaged.
1. Check if the Cleaner Blade does not have paper dust or
Cleaner Blade
bending.
Main Board 1. Check if the Main Board is not damaged.
Troubleshooting
Check point
1. Wipe off the remaining grease on the Carriage
1. Replace the ASF Unit with a new one.
1. Reassemble the Upper Paper Guide to the Main
Check point
1. Remove the foreign material around the seal
Seal rubber part
Compression
Spring1.47
2. Replace the Ink System Unit with a new one.
1. Perform CL operation and the Ink Cartridge
2. Replace the Printhead with a new one.
1. Replace Ink System Unit with a new one.
1. Replace the Main Board with a new one.
Revision B
Remedy
path and lubricate it on its frame.
Frame.
Remedy
rubber parts carefully.
replacement specified times. If it doesn't work,
change the Printhead with a new one.
64