Storage - Graco TrueCoat 360 Owner's Manual

Storage

NOTICE
Failure to store sprayer with Pump Armor
will result in operational problems the next
time you spray. Always circulate Pump
Armor through the sprayer after cleaning.
Water or solvents other than mineral
spirits left in the sprayer will corrode
and damage the pump.
Pump Armor fluid protects the sprayer while
in storage. It helps protect sprayer against
freezing and corrosion when not in use.
1. Clean the sprayer and cup assembly.
See Cleanup, page 13.
2. Turn Prime Pump/Spray knob down to
the Prime Pump position. Remove cup
support and FlexLiner. Make certain that
VacuValve cap is closed.
ti23285a
3. Separate the cup support with FlexLiner
from the cup cover/sprayer. Set the
sprayer upside down on a flat surface.
4. Remove strainer from pump opening.
5. With the sprayer upside-down pour
approximately 2 oz. (60 ml) Pump Armor
into pump opening.
6. Install strainer into pump opening.
333394F
Prime Pump
7. With sprayer upside-down attach cup
support with FlexLiner to sprayer.
8. Holding sprayer upside-down over a
waste container, pull sprayer trigger for
three seconds.
9. Remove cup assembly and pour any
remaining Pump Armour back into Pump
Armor bottle. Replace child-resistant
cap and tighten securely for storage.
10. Store sprayer indoors in a cool, dry
place. Store in an upright position
only. Never store sprayer with material
in the cup.
Storage
ti23707b
ti23388a
17