Common Procedures; Installing Spray Tips - Graco TrueCoat 360 Owner's Manual

Project series paint sprayers electric airless sprayer
Hide thumbs Also See for TrueCoat 360:
Table of Contents

Advertisement

Common Procedures

Common Procedures

Installing Spray Tips

Do not put your hand in front of the spray tip.
Two spray tips are available for use with this
sprayer. The black tip produces a 12-inch
wide spray pattern. The gray tip produces a
4-inch wide spray pattern.
Either spray tip may be used to spray mate-
rials that are recommended to be sprayed
with a 0.015 tip size. See material container
for spray tip size recommendations.
LOCKING TAB SLOT
ROTATE
SPRAY TIP 90
o
ti23563a
Remove Spray Tip
1.
Perform Pressure Relief Procedure,
page 13.
2.
Rotate the spray tip 90 degrees from
either the SPRAY or UNCLOG position.
18
3.
Install Spray Tip
1.
2.
3.
NOTE: Make certain spray tip locking tab is
pushed all the way into the slot in the spray tip
guard. You should not be able to remove the
spray tip from the spray tip guard when it is in
the Spray or Unclog positions.
NOTE: If the locking tab slot in the spray tip
guard is blocked, preventing installation of
the spray tip, rotate the spray tip guard until it
is visually aligned with the internal hole, then
LOCKING
install the spray tip.
TAB
REMOVE
SPRAY TIP
Pull the spray tip straight out of the spray
tip guard.
While holding the spray tip 90 degrees
from either the SPRAY or UNCLOG
position, align spray tip locking tab with
the locking tab slot in the spray tip guard.
Push the spray tip all the way into the
spray tip guard.
Rotate the spray tip to the SPRAY posi-
tion.
NOTICE
The spray tip guard is permanently
attached to the sprayer. Removal will result
in damage to the sprayer.
Spray tips wear with use and abrasive
paint and need periodic replacement.
If the spray pattern is poor, you may have
a worn spray tip. Replace spray tip. See
Spray Pattern Diagnostics, page 26.
NOTICE
Spray tips must be cleaned or stored in
appropriate cleaning fluid (water or mineral
spirits) immediately after use to ensure
material is not allowed to dry in spray tip.
Failure to do so will result in damage to the
spray tip. See Cleanup, page 13.
333394F

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents