Cornelius FCB - 2 Flavor Service Manual page 43

7. Install the magnet in the reverse order to removing it. Use
the magnet puller tool to install the magnet being careful
to insert the magnet slowly and not let it slam into the end
of the cylinder.
8. Inspect parts to see if they should be replaced, including
the beater bars, face plate, O-ring, and beater bar
bushing.
NOTE: Install faceplate by pressing until it contacts the
front of the cylinder. Reinstall 4 washers and nuts finger
tight. Then approximately 1/4 turn with a wrench.
9. When all the hardware is securely in place turn the
blendonator ON, then turn the product cylinder supply
valve ON, bleed the cylinder, and use the control panel to
turn the cylinder ON. There is a short delay before the
beater bar starts rotating.
© 2003-2014, Cornelius Inc.
Pinnacle 2 and 4 Flavor Service Manual
DO NOT let magnet slam into end of cylinder
Align
notched
hole in
beater bar
with
notched
rod on
shaft
Make sure
bushing on face
plate/beater bar
shaft is in good
condition
- 39 -
Magnet removal tool
FIGURE 32
FIGURE 33
FIGURE 34
Publication Number: 560007298SER