Resetting The Standard Product Defaults - Honeywell Hyperion 1300G User Manual

5. Follow the security directions as prompted on the screen and click on
Download.
6. When prompted, select Save, and save the file to your desktop.
7. Double click on the EZConfig-Scanning zip file.
8. Double click on the EZConfig-Scanning Setup.exe file. Select Extract
All.
9. Go to the EZConfig-Scanning folder that has been created on your
desktop and double click on the EZConfig-Scanning Setup.exe file.
10. Follow the screen prompts to install the EZConfig-Scanning program.
11. If you've selected the defaults during installation, you can click on the
shortcut on your desktop to start EZConfig for Scanning.
Once the software is installed, you may delete the zip file and the EZCon-
fig-Scanning folder from your desktop.

Resetting the Standard Product Defaults

This selection erases all your settings and resets the scanner to the
original factory defaults.
If you aren't sure what programming options are in your scanner, or you've
changed some options and want to restore the scanner to factory default set-
tings, first scan the Remove Custom Defaults bar code, then scan Activate
Defaults. This resets the scanner to the factory default settings.
Remove Custom Defaults
The Serial Programming Commands,
product default settings for each of the commands (indicated by an asterisk (*)
on the programming pages).
beginning on page 9-1 lists the standard
Activate Defaults
8 - 3