Honeywell Hyperion 1300G User Manual page 41

RTS/CTS Off, RTS Inactive: RTS/CTS is turned off so no data flow control is
used and RTS is inactive.
Flow Control, No Timeout: The scanner asserts RTS when it has data to
send, and will wait indefinitely for CTS to be asserted by the host.
Character-Based Flow Control, No Timeout: The scanner asserts RTS when
it has a character to send, and will wait indefinitely for CTS to be asserted by the
host
Two-Direction Flow Control: The scanner asserts RTS when it is OK for the
host to transmit. The host asserts CTS when it is OK for the device to transmit.
Flow Control with Timeout: The scanner asserts RTS when it has data to
send and waits for a delay (see RS232 Timeout on page 2-27) for CTS to be
asserted by the host. If the delay time expires and CTS is not asserted, the
device transmit buffer is cleared and scanning may resume.
Character-Based Flow Control with Timeout: The scanner asserts RTS
when it has a character to send and waits for a delay (see RS232 Timeout on
page 2-27) for CTS to be asserted by the host. If the delay time expires and
CTS is not asserted, the device transmit buffer is cleared and scanning may
resume.
CTS-Based Flow Control, No Timeout: When the host asserts CTS, scan-
ning is enabled. When CTS is not asserted, scanning is disabled.
RTS On: RTS only is on during transmission. CTS is ignored.
Default = RTS/CTS Off.
* RTS/CTS Off
RTS/CTS Off, RTS Inactive
Flow Control, No Timeout
2 - 25