TerraTrike Rover Auto NuVinci Operation Manual

PAIRING THE AUTOBIKE APP (FOR ANDROID 4.0 OR NEWER)
1. Open the app.
2. Accept the Bluetooth Permission request (Figure 1). If you don't see this request, continue to step three.
3. On the control module, press the Two Dot button. This will activate the system for 30 seconds.
4. Press"Scan for Devices" (Figure 2). If more than 30 seconds have passed since Step 3, repeat
that step to reactivate the system and then press "Scan for Devices."
5. Select "Auto Trike v1.2" from the device list (Figure 3).
6. When the trike starts to beep, roll forward until beeping stops.
7. Press "Pair" (Figure 4). You are now connected and can start using the app!
*Note: After this first pairing, the app will automatically connect to your Auto NuVinci system when the app
is opened and the system is on. If the app does become disconnected, go to "Settings" in the app and press
"Reconnect" while the Auto NuVinci system is on.
Contact TerraTrike customer service at:
sales@TerraTrike.com or 1-800-945-9910
or visit www.TerraTrike.com
Figure 1
Figure 2
Figure 3
Questions?
Figure 4
AUTO NUVINCI
Operation Manual