Replacing A Compactflash Memory Card - Cisco VG310 Hardware Installation Manual

Replacing a CompactFlash Memory Card

Procedure
Step 1 Read the
module.
Step 2
Press the ejector button next to the CompactFlash memory card. The ejector button moves outward so that it
projects from the panel.
Step 3 Press the ejector button again to eject the CompactFlash memory card partially out of its slot.
Step 4 Pull the memory card out of its slot.
Step 5
Push the ejector button until the button is flush with the chassis.
To prevent damage to the ejector mechanism, the ejector button must remain pressed all the way in (flush
against the bezel) when not being used to eject a CompactFlash memory card.
Figure 19: CompactFlash Memory Card Slot
1
Replacing a CompactFlash Memory Card
Procedure
Step 1 Read the
module.
Step 2 Make sure that the ejector button is fully seated until it is flush with the chassis.
Note
Cisco VG310 and Cisco VG320 Voice Gateways Hardware Installation Guide
50
Safety Recommendations, on page 13
Ejector button
Safety Recommendations, on page 13
If the ejector button is projecting out from the panel, push it in until it is flush with the chassis.
Installing the Cisco VG310 and Cisco VG320 Voice Gateways
and disconnect the power supply before you replace any
2 CompactFlash memory card slot
and disconnect the power supply before you replace any
OL-31292-01