Replacing The Ac Power Supply - Cisco VG410 Hardware Installation Manual

Replacing the AC Power Supply

Replacing the AC Power Supply
To replace or install an AC power supply into the device, perform these steps:
Step 1
Use the handle to push the power supply into the router. The power supply latch should provide an audible click when
the supply is fully seated.
Step 2
Install the AC power cord into the power socket on the power supply.
Step 3 If used, reapply the Velcro strap around the power cord and the power supply latch.
Step 4 If the device was turned off, turn the power back on to the device.
Cisco VG410 Voice Gateway Hardware Intallation Guide
30
Setting up the Power Supplies