Table of Contents
Advertisement
Troubleshooting
•
•
•
•
Locating LEDs and Components
The panel layouts for this appliance are described in:
•
•
Definitions of LED States
The various LED states are defined in the Cisco UCS C220 M5 Server Installation and Service Guide at
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/hw/C220M5/install/C220M5.html
Reset from the Internal Recovery Partition (IRP)
The Cisco Expressway CE1200 appliance comes pre-installed with an SD card that you can use to complete
a reinstall of your configuration. You must reset the SD card and enable the virtual drive before proceeding
with the reinstall using the KVM console in the Cisco Integrated Management Controller (CIMC). Once the
reset is complete, make sure that you disable the virtual drive again.
Before you begin
You need to set up and access the CIMC, as described in
Task 1: Reset the SD Card and Enable the Virtual Drive
Step 1
Log in to the CIMC.
Locating LEDs and Components, on page 31
Definitions of LED States, on page 31
Reset from the Internal Recovery Partition (IRP), on page 31
Lag During Boot up Due to Power Characterization Check, on page 33
Front Panel Layout
Rear Panel Layout
A P P E N D I X
Run the Install
Cisco Expressway CE1200 Appliance Installation Guide (14.0)
A
Wizard.
31
Advertisement
Table of Contents
