Chapter 6: Troubleshooting
Computer
The computer will not start
Make sure that the power cord is connected to an AC power source and your
■
computer is turned on.
Diskette drive
The diskette drive is not recognized
Shut down and restart your computer.
■
You cannot save a file to diskette or you see the message "disk is full or
write-protected"
Make sure that the write-protection tab on the upper-right corner of the diskette
■
is down (unprotected).
Delete unnecessary files on the diskette and try again.
■
Make sure that the diskette you are using is IBM-compatible.
■
Try a different diskette. Occasionally diskettes are flawed and cannot be read by
■
the diskette drive.
■
Run Error-checking on the diskette. For more information, see "Checking the hard
drive for errors" in Using Your Computer which has been included on your hard
drive. To access this guide, click
Documentation
If errors are detected and corrected, try using the diskette again.
You see a "Access Denied" or "Write protect" error message
Move the write-protection tab in the upper-right corner of the diskette down
■
(unprotected).
The diskette may be full. Delete unnecessary files on the diskette and try again.
■
Make sure that the diskette you are using is IBM-compatible.
■
■
Try a different diskette. Occasionally diskettes are flawed and cannot be read by
the diskette drive.
66
Start
.
www.gateway.com
,
, then click
All Programs
Gateway