Flavel Caress Installation And Maintenance Instructions Manual page 30

4.5.5 Fit the hexagonal control lever cable locking bush onto the control
lever and fit the control cable loosely into the bush in the gap between
the two lengths of p.t.f.e. sleeve. Ensure that the cable is located in the
retaining hole in the locking bush and tighten the screw sufficiently to
retain the cable but still allowing it to slide for adjustment.
4.5.6 It is now necessary to correctly tension the operating cable. To do this,
first set the control lever to the horizontal (central position), this is the
position which creates maximum tension in the operating cable.
Pull the free end of the operating cable through the operating arm until it
is finger tight and secure with screw into operating arm (do not over
tighten).
4.5.7 Slide the operating arm fully to the right hand position and hold in
position, slide the control lever relative to the cable until the cable
retaining screw lines up with the hole in the spacer frame. This sets the
control lever in the correct position. Hold the hexagonal locking bush
with a spanner and tighten the retaining screw using the 2mm allen key.
Move the control lever fully downwards and check that the left hand
micro-switch operates the igniter and that the control valve spindle is
fully depressed. Move the control lever upwards to the "off" position
and check that the right hand (cut-off) micro-switch operates. Check
that the control lever operates smoothly and safely.
PARTS SHORTLIST
Replacement of any other parts must be carried out by a competent person such
as a CORGI registered gas installer.
The part numbers of the user replaceable parts are as follows, these are available
from specialist spares stockists whose details can be found on our web site,
www.bfm-europe.com, in the 'stockist' section.
Fuelbed base
Fuelbed front rails (pair)
Replacement coal set
Complete ceramic set (base, front rails and coals)
ODS Pilot Assy. (NG)
ODS Pilot Assy. (LPG)
Ignition Wire
L/H fibre board
R/H fibre board
Rear fibre board
B-96400
B-96410
B-96420
B-96430
B-19660
B-19670
B-34690
20-20050
20-20060
20-16660
30