Table of Contents
Advertisement
FINAL TEST
1. Before final test unit was 4 days on burn-in-bench with music.
2. Take the unit from burn-in-bench to Q.C and play it immediately. Keep the line 120V A.C.
3. Check physically and check the components.
-check all capacitor and devices direction. Capacitor stand up right way i.e. check co-
solder.
-check any missing parts.
-check all fuse sockets.
-check main board tight up with screw and washer.
-check any screw missing.
-check balance lock working smoothly.
-check all output transistors position with pad.
-check main transistors position with pad.
-check main transformer tight very well.
4. Adjust bias 26mV for every output devices for both channels. Wait 7 to 8 minutes after
each adjustment. Also adjust offset to 0mV.
5. Measure rail and pre-driver voltage.
6. Measure A.C voltage for bridge.
7. Measure supply voltage for relays. +15V and 15V for both channels. +12V and 12V.
8. Measure reference voltage 8.1V on both channels.
9. Measure reference voltage for protection 78V.
10. After setting the bias, connect load and input signal. Check output signal. Check phase
with input signal.
11. Measure frequency response, slew rate, gain, signal to noise ratio.
12. Check the output signal from 20Hz to 20KH with load in following combination. Also
measure the output power.
Regegur-stereo
Balance-stereo
Regegur-mono
Balance-mono
13. Check phone-jack.
14. Check protection on both channels.
15. Check noise with speaker.
16. Put the jumpers and varistor for required A.C voltage.
17. Plug unit again and check rail and pre-driver voltage.
SSP-30
Classé - 15
Advertisement
Table of Contents
