Cleaning - Valor Black Beauty Radiant 340 Owner's Manual

about ten seconds to allow the flame sensing probe to warm up.
• The control knob can then be set to your preferred heat level. The settings are:
Knob
Position
2
3
4
5
• To turn off partially depress the knob and turn clockwise to off. Wait at least three
minutes before attempting to relight.
Lighting with a match or taper
• Depress the control knob and turn anticlockwise towards the ignition( 1 ) position.
• While keeping the knob depressed, light the pilot by inserting a long match or taper into
the pilot viewing opening (See figure 3).
• When the pilot is alight, keep the knob depressed for about ten seconds to allow the
flame sensing probe to warm up before setting to your preferred heat level.
• For your own convenience, have the heater serviced as soon as possible.
Turn the fire off and allow it to cool before attempting any cleaning.
Normally the fire will only need dusting. The bright metal trims may be cleaned with a
damp cloth and dried with a soft duster.
Obstinate marks can be removed from the guard and trims using soapy water. Never use
abrasive cleaners.
The radiants can be cleaned with a soft brush - see the next page for how to remove the
radiants.
OWNER'S GUIDE
Radiants Condition
Centre radiant on low. Outer radiants off.
Centre radiant fully on. Outer radiants off.
Centre radiant fully on. Outer radiants on low.
All radiants fully on.

CLEANING

Page 7