Detaching And Refitting The Eraser Lamp (Pwb) - Kyocera FS-1016MFP Service Manual

(5) Detaching and refitting the eraser lamp (PWB)

<Procedure>
1. Remove the laser scanner unit (See page
P.1-5-17).
2. Remove the one connector.
3. Remove the wire from two clamps.
4. Remove the wire form clamp.
5. Remove the sheet eraser.
6. Remove the eraser lamp (PWB).
7. Check or replace the eraser lamp (PWB)
and refit all the removed parts.
Clumps
Wire
Figure 1-5-23
Eraser lamp (PWB)
Eraser sheet
Figure 1-5-24
2G4
Connector
Wire
Clamp
1-5-19