Kyocera FS-1016MFP Service Manual page 36

2G4
Service error message
[SCANNER ERROR]
Motor Stall
Toner Low
Please Replace
Toner
1-4-4
Contents
Scanner motor stall for
scanner.
Toner low for printer.
Toner empty for
printer.
Causes Check procedures/corrective measures
Defective scanner Replace the scanner belt spring.
belt spring.
Poor contact in scan- Reinsert the connector (See page P.1-5-
ner motor connector 36).
terminals.
Defective FFC Reinsert the FFC. Also check for continuity
between main PWB within the FFC. If none, remedy or replace
and CCD PWB, or the FFC (See page P.1-5-29, P.1-5-28).
improper connector
insertion.
Defective scanner Replace the scanner motor (See page P.1-
motor. 5-36).
Defective main PWB. Turn the power switch off and then back on
again. If this message still remains, replace
the main PWB (See page P.1-5-29).
Defective scanner Replace the scanner unit (See page P.1-5-
unit. 22)
Toner is running low. Replace the toner container.
Defective toner con- Replace the toner container.
tainer.
Defective main PWB. Replace the main PWB (See page P.1-5-
29).
Toner has run out so Replace the toner container.
further copying or
printing is impossible.
Defective toner con- Replace the toner container.
tainer.
Defective main PWB. Replace the main PWB (See page P.1-5-
29).
Remarks